Tire Pressure Monitoring Display --, PERFORM THE BASIC SETTING
Applies Only to Tire Pressure Monitoring System Display -- with PR number 7K6 / 7K9
Perform the basic setting on the Tire Pressure Monitoring System Display -- only "after" the tire pressures have been adjusted to the correct values.
If no pressure loss and no tire damage is detected after a tire pressure warning, the erroneous warning can be eliminated by a basic setting.
The Tire Pressure Monitoring System Display -- compares the speed and the rolling circumference on each wheel using the ABS sensors. The tire pressure monitoring system display shows when there is a difference in the rolling circumference on a wheel. The rolling circumference changes when:
- the tire pressure is too low.
- Tires have structural damage.
- Vehicle is loaded on one side.
- wheels of one axle are loaded higher, for example, when towing trailer or driving uphill and downhill.
- Snow chains are installed.
- The emergency wheel is installed.
- One wheel per axle was replaced.
The yellow Tire Pressure Monitoring System Display Indicator Lamp -- is inside the instrument cluster -arrow-.
- "BLINKING LIGHT" indicates that no "BASIC SETTING" has been performed yet.
- "STEADY LIGHT", in conjunction with a warning tone, indicates "WARNING", a loss of pressure has been recognized, check tire pressure, perform system basic setting.
Perform the Basic Setting
-- Switch on the ignition.
-- Press the SET button inside the glove compartment for more than two seconds.
The Tire Pressure Monitoring System Display Indicator Lamp -- in the instrument cluster -arrow- stays on as long as the button is pressed.
Beginning of basic setting is confirm by a notifying tone.
On next new ignition start, warning does not appear.