RADIO CODE, CHECKING WITH Vehicle Diagnostic Tester

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Requirement for the Vehicle Diagnostic Tester

The Vehicle Diagnostic Tester is connected to the central database (Carport, Fazit) via the Central Partner Network (CPN).
The existing access authorization for the "GeKo" system

NOTE:

The radio code is also called safety code. The radio codes can be requested in the central database and shown on the Vehicle Diagnostic Tester display.

To activate the radio, the codes must be entered via the radio keys, as before RADIO/NAVIGATION SYSTEM, ENTER THE PIN FOR THE ANTI-THEFT CODE AND ASSIGN SOME LOCAL RADIO STATIONS TO THE STATION BUTTONS .

Procedure

-- Connect the Vehicle Diagnostic Tester. Refer to Vehicle Diagnostic Tester .

-- Switch on the ignition.

-- Select >>Guided Functions<<.

-- Select the following one after the other:

Brand
Type
Model year
Engine code

-- Confirm the VIN.

-- Select the following one after the other:

"Radio system".
"Request radio code".

-- Perform code request following the "Guided Functions".

Ending the Adaptation:

-- Select Go to and then press End .

-- Turn off the ignition and disconnect the diagnostic connector.

-- Switch on the ignition.