LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Maintenance Procedures (Convertible)) >> 03 Maintenance, Diagnosis >> Maintenance Procedures >> Headlamps, Check Hid Headlamps And Aim If Necessary >> Headlamp Adjustment, Checking, With Test Screen Without 15° Adjustment Line >> Test Diagram for Low Beam Version 2:

Test Diagram for Low Beam Version 2:

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Check the following: 

-- The lowest part of the horizontal bright/dark limit must touch the dash -1- on the test surface when the low beams are on.

Fig 1: Identifying Dash -1- And Break-Away Point -2-
GWWN01-11245Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Break-away point -2- between left horizontal part and rising part on right of light-dark border must run vertically through central point.

NOTE:

To make it easier to find break-away point -2- cover and uncover left half of headlamp (as viewed when looking forward) a few times. Then check dipped beam again.

scientia non olet · About LEMON Manuals