DTC MEMORIES, CHECKING WITH Vehicle Diagnostic Tester AND CORRECTING FAULTS ACCORDING TO REPAIR PROCEDURE

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Connect the Vehicle Diagnostic Tester. Refer to Vehicle Diagnostic Tester .

-- Select "OBD".

-- Select system "OBD".

-- Read the "Gateway device".

-- Correct any faults according to the repair procedure.

CAUTION:

In every case, the vehicle must be released to the customer with the DTC memory erased.

Static Malfunctions

If one or more static malfunctions exist in the DTC memory, we recommend in agreement with the customer, that these malfunction be resolved with the help of Guided Fault Finding.

Sporadic Malfunctions

In the case that only sporadic malfunctions or notes are stored in DTC memory and the customer has no complaints in conjunction with an electronic vehicle system, erase the DTC memory.

-- Press the "continue" > button again to access the test plan.

-- End Guided Fault Finding by pressing Go to . Then press the End button.

All DTC memories will be checked now once more.

The window that now appears confirms that all sporadic faults were cleared. The diagnostic protocol will be sent automatically "online".

Vehicle system test is completed.