Rear Disc Brake Pads

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench 40-200 Nm V.A.G 1332

Fig 1: Identifying Torque Wrench 40-200 Nm V.A.G 1332
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Flashlight and mirror

Perform the following procedure:

The adapter for loosening and tightening of anti-theft wheel bolts is part of the vehicle tool kit WHEEL BOLTS, TIGHTENING TO TIGHTENING SPECIFICATION .

-- Point a flashlight through an opening in the wheel rim.

-- Check thickness of outer pad visually.

Fig 2: Identifying Pad Thickness -A- Inner And Outer, Not Including Backing Plate

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Shine a flashlight on the inner pad and hold up a mirror.

-- Check thickness of inner pad visually.

a -

Pad thickness inner and outer, not including backing plate

Wear limit: 2 mm

With pad thickness (not including backing plate) of 2 mm, the brake pads have reached their wear limit and must be replaced (repair procedure). Inform the customer!

NOTE:

When replacing brake pads, it is absolutely necessary to check brake rotors for wear! Checking and replacing the brake pads, if necessary, is a repair measure.

-- Check the brake rotor for wear:

Procedure

Refer to GENERAL INFORMATION , DESCRIPTION AND OPERATION