Front Disc Brake Pads

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench 40-200 Nm V.A.G 1332

Fig 1: Identifying Torque Wrench 40-200 Nm V.A.G 1332
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Flashlight and mirror

Perform the following procedure:

The adapter for loosening and tightening of anti-theft wheel bolts is part of the vehicle tool kit WHEEL BOLTS, TIGHTENING TO TIGHTENING SPECIFICATION .

-- Use a mirror to determine the brake pad thickness. If necessary, remove the wheel where the brake pad wear display is installed.

-- Pull off wheel bolt covers if necessary WHEEL BOLTS, TIGHTENING TO TIGHTENING SPECIFICATION .

-- Mark the position of the wheel to the brake rotor.

-- Remove wheel bolts and then the wheel.

-- Measure thickness of inner and outer brake pad.

Fig 2: Identifying Pad Thickness -a- "Without" Backing Plate

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

a -

Pad thickness "without" backing plate

Wear limit: 2 mm

With pad thickness (not including backing plate) of 2 mm, the brake pads have reached their wear limit and must be replaced (repair procedure). Inform the customer!

NOTE:

When replacing brake pads, it is absolutely necessary to check brake rotors for wear! Checking and replacing the brake pads, if necessary, is a repair measure.

-- Check the brake rotor for wear:

Procedure

Refer to GENERAL INFORMATION , DESCRIPTION AND OPERATION

-- Install the wheel in the marked position.

-- Tighten the wheel bolts diagonally. For the correct tightening specification refer to WHEEL BOLTS, TIGHTENING TO TIGHTENING SPECIFICATION .

-- Return the adapter to the vehicle tools.

-- Pull off wheel bolt covers if necessary.