Overview - Crankcase Ventilation
WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Head Cover
- Seal
- Replace after removing
- Hose
- To the EVAP Canister Purge Regulator Valve 1 -N80-
- Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Hose
- For the crankcase ventilation
- To turbocharger
- Bolt
- 4 Nm
- Self-tapping
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- Seal
- Replace after removing
- Bolt
- Self-tapping
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- Tightening specification and sequence. Refer to Fig 2.
Oil Separator - Tightening Sequence
-- Tighten the bolts in the sequence -1 through 7-.
| Bolts | Tightening Sequence and Tightening Specification |
|---|---|
| -1 through 7- | 9 Nm |