Transmission Input Speed Sensor -G182- AND Clutch Oil Temperature Sensor -G509-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Only install the >>old<< sensor if the sensor is working correctly and the wire was not pulled out.

-- Coat the sensor with transmission fluid and then install.

-- Tighten the bolt to the tightening specification.

-- Install the DSG Transmission Mechatronic -J743-. Refer to MECHATRONIC, REMOVING AND INSTALLING .

Do not pinch line when installing Mechatronic!