Vibration Damper Sealing Ring, Replacing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Crankshaft Seal Installer T10354

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Clean the running and sealing surface.

-- Push the seal -arrow- on the : T10354 .

The closed side of the seal points to the : T10354 .

-- Push the seal -arrow- with the : T10354 on the : T10531/2 and place on the lower timing chain cover.

Fig 2: Identifying Crankshaft Seal Installer T10354 And Tensioning Pins T10531/2

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Additionally attach the : T10375 and tighten the : T10531/4 .

Fig 3: Driving Seal In Using Seal Installer - Crankshaft T10354

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Drive the seal in all the way using the : T10354 .

NOTE:

Replace the vibration damper bolt.

Replace the O-ring.

Further assembly is performed the reverse order of the removal. Pay attention to the following:

-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .