Overview - Camshaft Housing
WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Head
- Ball Pin
- 9 Nm
- For engine cover
- O-Ring
- Replace after removing
- Coat with engine oil
- Plugs
- Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 3.
- Seal
- Replace after removing
- Vacuum Pump
- Removing and installing. Refer to VACUUM PUMP, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to Fig 2.
- Gasket
- Replace if damaged
- O-Ring
- Replace after removing
- Coat with engine oil
- Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolts
- 9 Nm
- Bracket
- For EVAP Canister Purge Regulator Valve 1 -N80-
Tightening Specifications - Vacuum Pump
Tighten with a new bolts as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 3- | Install hand-tight |
| 2. | -1 through 3- | 8 Nm |
| 3. | -1 through 3- | 180° additional turn |