LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Crankshaft, Cylinder Block [CPLA,CPPA,CPKA,CPRA]) >> 13 Crankshaft, Cylinder Block >> Piston And Connecting Rod >> Pistons, Removing And Installing >> Removing

Pistons, Removing And Installing: Removing

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Secure the engine to the : VAS6095A  . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Label the installation position and the cylinder allocation for the piston.

-- Mark installation position and connecting rod cylinder -Item  ) OVERVIEW - PISTON AND CONNECTING ROD - List Item: Connecting Rod.

-- Remove the connecting rod bearing cap and remove the piston and connecting rod upward.

NOTE:

If difficult to move, heat the pistons to approximately 60 °C (140 °F).

-- Remove the circlip from the piston pin eye.

-- Remove the piston pin using the : VW222A  .

scientia non olet · About LEMON Manuals