Overview - Cylinder Block, Transmission Side
WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Flywheel
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Only possible to install in one position - Bores are offset
- Alignment Sleeve
- Sealing Flange, Transmission Side
- With seal
- Replace only as a complete unit.
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Do not oil or grease the sealing lip of seal
- Wipe off any oil on the crankshaft bearing pin with a clean cloth before installing.
- Guide sleeve may only be removed after the sealing flange has been slid onto the crankshaft pin.
- Cylinder Block
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Intermediate Plate
- The illustration does not show the version in the vehicle.
- Must be located on alignment sleeves
- Be careful not to damage or bend when installing
- Is hooked in at sealing flange. Refer to Fig 3
- Alignment Sleeve
- Bolt
- 60 Nm +90°
- Replace after removing
- For the dual-mass flywheel
Ribbed Belt Transmission Side Sealing Flange - Tightening Specifications and Sequence
-- Tighten the bolts in steps in the sequence -1 to 6- :
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 6- | Install all the way in by hand. |
| 2. | -1 through 6- | 9 Nm |
NOTE:
Only six bolts are installed, two bolt openings remain open.
Installing Intermediate Plate
-- Hook in intermediate plate at sealing flange and push it onto the alignment sleeves -arrows-.