Vibration Damper, Removing And Installing: Installing

Fig 1: Identifying Collar Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If necessary remove the : T10531/4  -B- and the : T10531/3  -A- from the tensioning pins.

-- Secure the vibration damper in TDC, while doing this pay attention to the tooth contour of the chain sprocket -arrow-.

Fig 2: Identifying TDC

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the : T10531/3  -A- on the tensioning pins while the hex fitting points to the vibration damper.

Fig 3: Identifying Turning Over Tool And Collar Nut

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the : T10531/4  -B-, while doing this move the vibration damper slightly back and forth, to check if the vibration damper is seated correctly in the tooth contour. Tighten the collar nut, until the vibration damper can no longer be turned.

-- Place the : T10531/1  as shown on the vibration damper and tighten hand-tight using the knurled bolt -arrows-.

Fig 4: Identifying Assembly Tool Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the : T10531/4  -A- and loosen the adjusting bolt -B-. Remove the : T10531/2  and remove with : T10531/3  .

Fig 5: Identifying Collar Nut And Tensioning Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install a new vibration damper bolt with an oiled O-ring -1- hand-tight.

Fig 6: Identifying Vibration Damper Bolt And O-Ring

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the knurled bolt -arrows- and remove the : T10531/1  .

Fig 7: Identifying Assembly Tool Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten vibration damper bolt using the : T10355  .

Fig 8: Identifying Vibration Damper Counterhold

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install new bolts -arrows-.

Fig 9: Locating Timing Chain Cover Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Further assembly is performed the reverse order of the removal.