Subassembly Bracket, Removing And Installing: Installing

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace the O-rings and seals.

-- Coat the new O-rings -4- with coolant. Refer to the Parts Information for the coolant.

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the connection -2- into the coolant pump housing -3-.

-- Slide the auxiliary components bracket -1- onto the connection and then install and tighten the bolts. Refer to Figure.

-- Fill with coolant. Refer to Filling .

-- Install the oil and check the oil level. Refer to ENGINE OIL, DRAINING OR EXTRACTING; REPLACING OIL FILTER AND FILLING ENGINE OIL .