Exhaust System, Installing Without Tension: Procedure

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Align the exhaust system when cold.

NOTE:

The -arrow- points in the direction of travel.

-- Loosen the bolts for the front clamping sleeve -arrow-.

Fig 1: Locating Clamping Sleeve Screws

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the exhaust system far enough forward until the pre-load on the retaining loops at the exhaust pipe -a- = 9 mm.

Fig 2: Identifying Tail Pipe Aligning

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.