SUBFRAME Mount, Checking Adjustment
WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- There must be at least 10 to 13 mm -a- between engine support and right longitudinal member.
- The casting edge on the engine support -a- must stand parallel to the support arm.
- Dimension -b- = Dimension -b-.
NOTE:
Distance -a- can also be checked using a suitable round stock.
Only if There is Noise (the Engine or Transmission Hitting the Longitudinal Member When Driving Around Curves) and Dimension -a- is not within 10 to 13 mm:
-- Adjust the subframe mount. Refer to SUBFRAME MOUNT, ADJUSTING .