Overview - SUBFRAME Mount: Notes

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Assembly Mounts Exploded View

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt
- Replace after removing
- Engine support to engine
- Tightening specification. Refer to Figure.
Engine Mount
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- 40 Nm +90°
- Replace after removing
- Engine mount to body
Bracket
Bolt
- 20 Nm +90°
- Replace after removing
- Bracket to engine mount and body
Bolt
- 40 Nm +90°
- Replace after removing
- Engine mount to body
Bolts
- 60 Nm +90°
- Replace after removing
- Engine mount to engine support
Pendulum Support
- Removing and installing. Refer to Figure.
- First install pendulum support to the transmission and then to the subframe
Bolt
- Tightening specification. Refer to Figure
- Replace after removing
- Pendulum support to subframe
Bolts
- Tightening specification. Refer to Figure
- Replace after removing
- Pendulum support to transmission
Bolt
- 60 Nm +90°
- Replace after removing
- Transmission mount to transmission support
Bolt
- 40 Nm +90°
- Replace after removing
- Transmission mount to body
Transmission Mount
- The illustration shows the DSG^® transmission version
Transmission Support
Bolt
Tightening specification:
- Vehicles with a manual transmission. Refer to TRANSMISSION, REMOVING AND INSTALLING .
- Vehicles with a DSG^® transmission. Refer to TRANSMISSION, REMOVING AND INSTALLING .
- Double bolt
- Transmission support to transmission
Bolt
Tightening specification:
- Vehicles with a manual transmission. Refer to TRANSMISSION, REMOVING AND INSTALLING .
- Vehicles with a DSG^® transmission. Refer to TRANSMISSION, REMOVING AND INSTALLING .
- Transmission support to transmission
Engine Support
- Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .