Installing Pendulum Support
WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
-- First install the pendulum support -4- to the transmission and then to the subframe.
-- Tighten the bolts in steps in the sequence shown:
| Step |
Bolts |
Tightening Specification/Additional Turn |
| 1. |
-2 and 3- |
50 Nm |
| 2. |
-1- |
100 Nm |
| 3. |
-1 through 3- |
Turn an additional 90°. |