Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

Fig 1: Identifying Coolant Expansion Tank And Windshield Washer Fluid Reservoir Filler Tube

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -4- and rotate the windshield washer fluid reservoir filler tube -2- forward.

-- Open the clip -3- and remove the connector -5- from the coolant expansion tank -1-.

-- Remove the bolts -arrows- and place the coolant expansion tank -1- on the engine with the coolant lines connected.

-- If equipped, remove the battery jump start terminal -3- on the front engine mount bolt -2- using the :T40055 .

Fig 2: Identifying Union Nut Socket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -5- and the bracket -4-.

Fig 3: Identifying Engine Mount Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -1 and 3- and then remove the engine mount upward.