Fresh Air Blower Series Resistor with Fuse -N24-: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the plastic screws -2- and the front passenger side footwell trim panel -1-.

Fig 1: Identifying Partition

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1- from the Fresh Air Blower Series Resistor With Fuse -N24- -2-.

-- Push the locking mechanism in the direction of -arrow A- and slide the Fresh Air Blower Series Resistor With Fuse -N24- -2- in the direction of -arrow B-.

-- Remove the Fresh Air Blower Series Resistor With Fuse -N24- -2- from the heater and A/C unit -3-.

Fig 2: Identifying Fresh Air Blower Series Resistor With Fuse

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.