LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Engine Assembly [CPLA,CPPA,CPKA,CPRA] (Convertible)) >> 10 Engine Assembly >> SUBFRAME Mount >> Overview - SUBFRAME Mount >> Installing Pendulum Support

Installing Pendulum Support

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Assembly Mounts - Tightening Specification and Sequence
GWWM10-10034Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- First install the pendulum support -4- to the transmission and then to the subframe.

-- Tighten the bolts in steps in the sequence shown:

Step Bolts Tightening Specification/Additional Turn
1. -2 and 3- 50 Nm
2. -1- 100 Nm
3. -1 through 3- Turn an additional 90°.
scientia non olet · About LEMON Manuals