LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (Turbocharger, Supercharger [CPLA,CPPA,CPKA,CPRA] (Convertible)) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING >> Removing

Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2017 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Fig 1: Identifying Charge Air Pressure Sensor
GWWM21-10014Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- and pull the Charge Air Pressure Sensor -G31- -1- out of the air duct pipe and remove it upward.

NOTE:

The bolts are each accessible in front of and behind the coolant hose from above.

scientia non olet · About LEMON Manuals