Only for Vehicles Equipped With a Twin Clutch Transmission
WARNING: This page is about a different car, the 2015 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Adapter Puller - Kukko Counterstay 22/1
- Puller - Kukko Internal - 14-19 mm 21/2
- Bearing Installer - Bearing Press Piece VW 207C
NOTE:
In vehicles with twin clutch transmission, the needle bearing must be installed at rear in crankshaft.
Conditions:
- Always replace the needle bearing -arrow- after the engine and transmission are separated.
- The front edges of the internal puller must not be broken off.