Removal And Installation: Pistons: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the bolts were tightened with an additional turn.

Arrow on piston face points toward belt pulley side.

Offset the piston ring gap by 120°.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston with a piston ring compressor. Pay attention to the installed position -item 8 8.

-- Install the connecting rod bearing cap. Pay attention to the installed position -item 2.

-- Install the cylinder head, refer to CYLINDER HEAD .

-- Install the oil pan upper section, refer to OIL PAN UPPER SECTION .