LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (1.8L & 2.0L - Crankshaft, Cylinder Block - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Hatchback)) >> 13 Crankshaft, Cylinder Block >> Removal And Installation >> Cylinder Block, Transmission Side >> Flywheel >> Removing

Cylinder Block, Transmission Side: Flywheel: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Dual-Mass Flywheel & Bolts
GWWA30-0102Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
CAUTION:

Danger of causing damage to the flywheel.

  • Remove the bolts -B- by hand. Do not use an air-powered or impact wrench.
  • When removing bolts, ensure bolt head does not come in contact with the flywheel.
  • Turn the flywheel -A- until the bolts -B- line up with the holes -arrows-.

-- Place the Flywheel Retainer 3067 into the hole on the cylinder block -B-.

Fig 2: Identifying Flywheel Retainer
GWWN13-10563Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen and remove bolts for flywheel.

scientia non olet · About LEMON Manuals