LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (1.8L & 2.0L - Crankshaft, Cylinder Block - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Hatchback)) >> 13 Crankshaft, Cylinder Block >> Removal And Installation >> Cylinder Block, Belt Pulley Side >> Ribbed Belt TENSIONER >> Removing

Ribbed Belt TENSIONER: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the right front wheel housing liner. .

-- Remove the ribbed belt from the tensioner, refer to RIBBED BELT .

Fig 1: Identifying Tensioning Damper
GWWA13-10906Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- and pull the ribbed belt tensioning damper -1- off the sub-assembly bracket.

scientia non olet · About LEMON Manuals