LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (1.8L & 2.0L - Crankshaft, Cylinder Block - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Hatchback)) >> 13 Crankshaft, Cylinder Block >> Description And Operation >> Overview - Balance Shaft

Overview - Balance Shaft

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Balance Shaft Overview
GWWA13-10964Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Bolt
    • 4 Nm +45°
    • Replace after removing
  2. Balance Shaft
    • Must be replaced after removing
    • Exhaust side
    • Lubricate the bearing with engine oil
    • Replacing, refer to BALANCE SHAFT, EXHAUST SIDE .
  3. Needle Bearing Rim
    • No replacement part, part of the balance shaft delivery package
  4. Pipe for the Balance Shaft
    • Installed position, refer to Fig 2
  5. Cylinder Block
  6. Balance Shaft Seal Intake Side
  7. Balance Shaft
    • Intake side
    • Must be replaced after removing
    • Lubricate the bearing with engine oil
    • Replacing, refer to BALANCE SHAFT, INTAKE SIDE .
  8. Needle Bearing Rim
    • No replacement part, part of the balance shaft delivery package
  9. Bolt
    • 4 Nm +45°
    • Replace after removing
Fig 2: Balance Shaft Pipe - Installed Position
GWWA13-10967Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
scientia non olet · About LEMON Manuals