Brake Pads, Rear Brakes CI 38: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

WARNING: Adjust the brake piston is permitted only with the Brake Caliper Tool T10165.

-- Loosen the wheel bolts.

-- Raise the vehicle.

-- Remove the wheel.

-- Remove the brake caliper -1- from the brake carrier -2-.

Fig 1: Identifying Brake Caliper & Brake Carrier

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To do this, remove the bolts -arrows-.

-- While doing so counterhold the guide pin on the brake carrier -2- with a suitable wrench -3-.

Fig 2: Removing Brake Caliper From Brake Carrier

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove brake caliper -1- and secure with wire so that the weight of the brake caliper does not stress or damage the brake hose.

-- Remove the brake pads -2- from the brake carrier -1-.

Fig 3: Locating Brake Pads On Brake Carrier

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Cleaning:

WARNING: Do not blow brake system using compressed air, the dust produced is harmful to health!

Use only appropriate solvents for cleaning brake caliper.

Fig 4: Identifying Brake Carrier And Brake Pad Contact Surfaces

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Thoroughly clean the contact surfaces -arrows - for the brake pads on the brake carrier -1- and remove any corrosion.