Cover Plate, Brake Caliper FS III: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE: Before installing, clean carefully and check for wear and damage.

If using the brake pads again, install the marked pads in the same location.

Before pushing back the piston, extract some of the brake fluid out of the brake fluid reservoir using a bleeder bottle. Otherwise, especially if reservoir has been topped off, fluid will overflow and cause damage.

-- Install the wheel and tighten. Refer to REMOVAL AND INSTALLATION .

NOTE:

Before moving the vehicle, press the brake pedal firmly several times to seat the brake pads correctly in their operating position.

Check brake fluid level.