Brake Carrier, Brake Caliper FN3: Removing
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.
Do not open the brake hydraulic system when removing!
-- Loosen the wheel bolts.
-- Raise the vehicle.
-- Remove the wheel.
-- Remove brake pads. Refer to REMOVING .
-- Remove brake caliper and secure with wire so that the weight of the brake caliper does not burden or damage the brake hose.
-- Unscrew the threaded connection -arrows- from the cover plate -1-.
-- Remove the brake carrier -1-.
Cleaning:
WARNING:
Do not blow brake system using compressed air, the dust produced is harmful to health!
Clean brake caliper with mineral spirits exclusively.