Parking Brake, Adjusting, Drum Brake: Adjusting
-- Raise the vehicle.
Vehicles without Center Armrest:
-- Remove the mat from the storage compartment.
-- Open access cover -1- in the center console.
Vehicles with Center Armrest:
-- Remove the cover -1- on the center armrest -2-.
-- Remove the nut -1- on the center armrest -2-.
-- Remove the center armrest. Refer to REMOVAL AND INSTALLATION .
Continuation for all vehicles:
-- Press the brake pedal forcefully at least three times.
When Replacing a Brake Cable:
-- Attach the parking brake cables -2- to the parking brake lever. Refer to -item 3-.
Continuation for all vehicles
-- Tighten adjusting nut -1- until parking brake lever goes back into rest position by itself under the first detent.
-- Tighten hand brake to stop 3 times and then loosen again.
The parking brake lever must go back into the rest position by itself under the first detent.
- Parking brake lever in released position.
-- Engage parking brake 2 teeth.
-- Tighten the adjusting nut -1- enough until both wheels no longer move by hand.
-- Release parking brake.
- Parking brake lever in released position.
-- Check whether wheels turn freely.
-- Check to see if the compensator. Refer to -item 5- is standing straight.
Due to the automatic rear brake adjuster, there is no need to adjust the parking brake after making initial adjustment.