Overview Without Brake Pad Wear Indicator, Brake Caliper FN 3
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
After replacing brake pads, depress brake pedal several times firmly to properly seat brake pads in their normal operating position.
Use Brake Charger/Bleeder Unit VAS 5234 to extract brake fluid from brake fluid reservoir.
Install the Brake Pedal Actuator VAG 1869/2 to relieve pressure before removing a brake caliper or disconnecting a brake hose.
- Bolt
- 8 Nm
- Brake Rotor
- Ventilated inside, 288 mm diameter, 15 inches
- Ventilated inside, 312 mm diameter, 16 inches
- Thickness 25 mm
- Wear limit: 22 mm
- Replace in pairs
- Removing and installing. Refer to BRAKE ROTOR, BRAKE CALIPER FN 3 .
- Do not use excessive force to separate the brake rotor from the wheel hub. If necessary, use rust penetrant, otherwise the brake rotors could be damaged.
- Brake Pads
- Thickness 14 mm without backing plate
- Wear limit: 2 mm without backing plate
- Checking thickness. Refer to BRAKE PAD THICKNESS AND FRONT AND REAR BRAKE ROTOR CONDITION, CHECKING
- Replace in pairs
- Removing and installing. Refer to BRAKE PADS, BRAKE CALIPER FN3 .
- Spring
- Insert in both holes of brake caliper
- Brake Carrier
- Removing and installing. Refer to BRAKE CARRIER, BRAKE CALIPER FN3 .
- Brake Caliper
- Do not remove the brake hose when changing the brake pads.
- Removing and installing. Refer to BRAKE CALIPER, BRAKE CALIPER FN3 .
- Servicing. Refer to FRONT BRAKE CALIPER PISTON .
- Guide Pin
- 30 Nm
- Cap
- Brake Hose with Ring Connection and Banjo Bolt
- 35 Nm
- Bolt
- 200 Nm
- Clean if using again.
- Wheel Bearing Housing
- With fastened brake carrier
- Front Speed Sensor --
- Before inserting the sensor, clean inner surface of the hole and coat with Hot Bolt Paste G 052 112 A3.
- Removing and installing. Refer to RIGHT/LEFT FRONT ABS WHEEL SPEED SENSOR -G45- / -G47- .
- Bolt
- 8 Nm
- Cover Plate
- Removing and installing. Refer to COVER PLATE, BRAKE CALIPER FN 3 .
- Bolt
- 12 Nm
- Wheel Bearing Unit
- The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing