Adjusting Angle

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the side trim panel, refer to Removal and Installation .

Fig 1: Identifying Speaker Housing With Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the electric wire -1- on the speaker housing -3-.

-- Disconnect the cable -4- from the speaker housing.

-- Remove the bolts -2-.

-- Pull the speaker housing -3- forward, but do not remove it completely.

NOTE:

The side window -2- lines up when the door window -1- is adjusted correctly.

It should be at the same height and aligned with the door window.

The side window must move into the convertible top seal as shown -3- -arrows a-.

Fig 2: Identifying Adjusting Screw And Window Regulator

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lower the side window all the down to adjust the angle.

-- Adjust the side window angle using the adjusting screw -5- on the window regulator -4-.

-- Perform a functionality test and check the adjustment with the convertible top open and closed.

Fig 3: Identifying Speaker Housing With Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the speaker housing -3- and tighten the bolts -2-.

-- Assemble in reverse order of removal.

-- Install the side panel, refer to Removal and Installation .