LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (1.8L & 2.0L Turbocharger, Supercharger - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Hatchback)) >> 21 Turbocharger, Supercharger >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Components Fastener Size Nm
Heat shield bolt1 - 9
- 20
Turbocharger Recirculation Valve -N249- nut - 7
Turbocharger Recirculation Valve -N249- bolt - 7
Coolant supply line bolt - 9
Oil Return Pipe bolt2 - 9
- 25
Coolant supply line bolt - 9
Support brace bolt - 30
Heat shield to support brace bolt - 30
Oil supply line bolt - 9
Turbocharger nut3 - 25
Turbocharger Recirculation Valve -N249- heat shield bolt - 4.5
V-clamp3 - 15
Charge Pressure Actuator -V465- nut - 7
Charge air cooler upper rubber bushing bolt - 8
Air guide pipe bolt - 7
  • 1 : For bolt tightening clarification, refer to OVERVIEW - TURBOCHARGER  and see items -2, 3, 4-.
  • 2 : For bolt tightening clarification, refer to OVERVIEW - TURBOCHARGER  and see items -17, 19-.
  • 3 : Replace after removing.
  • 4 For bolt tightening clarification, refer to and see items --
  • 5 For bolt tightening clarification, refer to and see items --
  • 6 For bolt tightening clarification, refer to and see items --
scientia non olet · About LEMON Manuals