LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (1.8L & 2.0L Turbocharger, Supercharger - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Hatchback)) >> 21 Turbocharger, Supercharger >> Removal And Installation >> Charge Air Pressure Sensor -G31- >> Removing

Charge Air Pressure Sensor -G31-: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove air filter housing, refer to AIR FILTER HOUSING .

-- Disconnect the connector -2-.

Fig 1: Identifying Charge Air Pressure Sensor
GWWM21-10014Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- and pull the Charge Air Pressure Sensor -G31- -1- out of the air guide pipe and remove it upward.

NOTE: The bolts are each accessible in front of and behind the coolant hose from above.
scientia non olet · About LEMON Manuals