LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Passenger Protection, Airbags & Seat Belts (Hatchback)) >> 69 Passenger Protection, Airbags, Seat Belts >> Removal And Installation >> Driver Side Airbag >> Airbag Unit With Igniter >> Installing

Airbag Unit With Igniter: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the airbag connector -1- in the connector. The airbag connector must click when it locks.

Fig 1: Identifying Airbag Connector, Connector And Airbag Unit
GWWM69-10068Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the connector -2-. This is necessary only on the multifunction steering wheel.

-- Press the airbag unit -3- into the steering wheel until it audibly engages.

-- Gently pull on the airbag unit to make sure the it is locked securely inside steering wheel on the left and right sides.

-- Turn on the ignition.

WARNING: Make sure that no persons are in the vehicle.

-- Connect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .