Fiber-Optic Cables, Repairing: Procedure
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
-- Choose "Guided Fault Finding" or "Guided Functions" in the Vehicle Diagnostic Tester.
-- Assemble the fiber-optic cable, refer to FIBER-OPTIC CABLE, ASSEMBLING .
CAUTION:
Do not bend the fiber-optic cable too much. The bending radius must be no less than 25 mm.
Fiber optic cables must not be routed over sharp edges.
The fiber-optic cable must not be dirty or touched with bare fingers.
Fiber optic cables may not be heated.
It is not permitted to twist together 2 fiber optic cables or one fiber optic cable with a copper wire.
Protect the connector and the connection box from dust. Place the cap on the trunk.