LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Wiring - General Information (Hatchback)) >> 97 Wiring >> Contact Surfaces, Cleaning >> Contact Surface Cleaning Set VAS 6410 >> Battery Clamps And Battery Terminals, Cleaning >> Procedure

Battery Clamps And Battery Terminals, Cleaning: Procedure

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the Battery -A-, refer to [For transmission(s) 0A4, 02E, 09G, 02Q] [For engine(s) CVCA, CPRA, CBTA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Battery, Starter, Generator, Cruise Control .

-- Check the battery terminal and battery pole for corrosion and dirt.

The battery terminal clamp is cleaned with the battery terminal cleaner wire brush using circular motions.

Fig 1: Cleaning Battery Terminal Clamp
GWWN97-10792Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The battery terminal is cleaned with the bottom side of the terminal cleaner using circular motions.

Fig 2: Cleaning Battery Terminal
GWWN97-10793Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
WARNING: Risk of injury. Follow all warning messages and safety precautions, refer to WARNINGS AND SAFETY PRECAUTIONS .

-- Connect the Battery -A-, refer to [For transmission(s) 0A4, 02E, 09G, 02Q] [For engine(s) CVCA, CPRA, CBTA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Battery, Starter, Generator, Cruise Control .