Individual Parts of the Disassembled DSG Clutch
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- This illustration is only an overview of the components. The DSG clutch must not be disassembled at this time since all outer and inner clutch discs were installed weighted to each other.
- If drive plate is loosened, the clutch discs in the DSG clutch can slip out of place and the DSG clutch may not be correctly set during installation under certain circumstances.
- DSG Clutch/Clutch Housing
- Outer clutch pack carrier
- Seals
- Quantity: 4
- Inner Clutch Pack Carrier
- Do not removeCAUTION: Do not lift or remove the inner clutch pack carrier, under any circumstances. The clutch discs could rotate themselves.
- Do not remove
- Outer Discs
- Quantity: 4
- Inner Discs
- Quantity: 4
- Thrust Washer
- Locking Ring
- In the event the securing ring was removed in order to reinsert discs, it should be replaced with a new ring of the same thickness.
- Locking Ring
- Reset after installing a new clutch thickness. Refer to IDENTIFY THE LOCKING RING FOR THE DSG CLUTCH
- Drive Plate
- Locking Ring
- Replace after removing