Clutch Overview, With Dual Mass Flywheel, SACHS
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
- Dual Mass Flywheel
- Removing and installing, refer to one of the following:
Gas engine, refer to [For engine(s) CPLA, CPPA] Removal and Installation[For engine(s) CVCA] Removal and Installation[For engine(s) CCTA, CBFA] Removal and Installation[For engine(s) CVCA, CJAA] Removal and Installation .
Diesel engine, refer to [For engine(s) CPLA, CPPA] Removal and Installation[For engine(s) CVCA] Removal and Installation[For engine(s) CCTA, CBFA] Removal and Installation[For engine(s) CVCA, CJAA] Removal and Installation .
- Make sure it fits securely on the alignment pins.
- Keep the clutch lining contact surface free of grooves, oil and grease.
- Removing and installing, refer to one of the following:
- Clutch Disc
- Grease allocation.
- Only replace together with the pressure plate -3-.
- Removing and installing, refer to CLUTCH, WITH DUAL MASS FLYWHEEL, SACHS .
- Installed position, refer to Figure.
- Pressure Plate
- With an adjustment mechanism.
- Grease allocation.
- Only replace together with the clutch disc -2-.
- Removing and installing, refer to CLUTCH, WITH DUAL MASS FLYWHEEL, SACHS .
- Checking the ends of the diaphragm spring. Refer to Figure.
- Checking the spring and rivet connections. Refer to Figure.
- Approximately from May 2011: release bearing with an additional plastic washer, refer to Figure, pressure plate is adapted, refer to Figure.
- Bolt
- M6 - 13 Nm.
- M7 - 20 Nm.
- Loosen and tighten in small steps and in a diagonal sequence.
- Grease allocation.