Accessory Bracket: Installing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal. Note the following:

NOTE:

For the correct tightening specifications, refer to RIBBED BELT DRIVE OVERVIEW .

Replace the bolts that have been tightened to an additional torque angle.

Replace the O-rings and seals.

-- Coat the new O-rings -4- with coolant.

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the connection -2- into the coolant pump housing -3-.

-- Press the accessory bracket -1- onto the connection, mount the bolts and tighten them, refer to Figure.

-- Install the A/C compressor. Refer to REMOVAL AND INSTALLATION .

-- Install the generator. Refer to REMOVAL AND INSTALLATION .

-- Install the ribbed belt. Refer to Installing .

-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .