LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (2.0L - Crankshaft, Cylinder Block - Engine Code(S): CBFA & CCTA (Hatchback)) >> 13 Crankshaft, Cylinder Block >> Diagnosis And Testing >> Piston Ring Gap, Checking >> Test Sequence

Test Sequence

WARNING: This page is about a different car, the 2013 Volkswagen Beetle and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Push the ring squarely from above, down to approximately 15 mm from the bottom end of the cylinder. To do this use a piston without rings.

Piston Ring Gap
Dimensions in mm New Wear limit
Compression rings 0.20...0.40 0.80
Oil scraping ring 0.25...0.50 0.80
scientia non olet · About LEMON Manuals