LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 190 (1.8L & 2.0L - Engine Assembly - Engine Code(S): CPKA, CPLA, CPPA & CPRA (Hatchback)) >> 10 Engine Assembly >> Removal And Installation >> Transmission Mount >> Installing

Transmission Mount: Installing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Fasten the transmission mount A on the longitudinal member.

CAUTION: Risk of damaging threads in transmission support by inserting bolts crooked.
  • The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing bolts. Push the transmission up using a floor jack if necessary.
  • Only remove the Engine Support Bridge 10-222A when bolts for subframe mount are tightened to tightening specification.

-- Pull the transmission up using the spindle on the engine support bridge until the transmission support touches the transmission mount support arm.

-- Check the adjustment of the assembly mounts, refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the Engine Support Bridge 10-222A from the engine.

scientia non olet · About LEMON Manuals