Engine, Securing On Engine And Transmission Holder: Procedure

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

The transmission is separated from the engine, refer to ENGINE AND TRANSMISSION, SEPARATING .

-- Unlock the retaining tab -arrow- and remove the engine cover mount -1-.

Fig 1: Identifying Engine Cover Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the mount -1- for the right engine cover -2- from the bore.

Fig 2: Identifying Engine Cover Mount And Locating Bore

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Hook the Engine Sling 2024A to the engine and to the Shop Crane VAS6100.

Fig 3: Identifying Engine Lifted

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE: To be aligned to the center of gravity of the engine assembly, the hole rails of the lifting hook must be inserted as shown in the graphic.

WARNING: Loose engine support bridge components could cause an accident.

Secure the mounting hooks and pins on the engine support bridge using securing pins -arrows-.

-- Lower the engine from the Engine/Gearbox Jack VAG1383A using the Shop Crane VAS6100.

-- Secure the transmission side of the engine to the Engine And Transmission Holder VAS6095 as shown.

Fig 4: Identifying Engine And Transmission Holder

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.