Engine Mount: Removing

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in its installed position, refer to ENGINE, SUPPORTING IN INSTALLED POSITION .

-- Remove the bolt -4- and rotate the windshield washer fluid reservoir filler tube -2- forward.

Fig 1: Identifying Coolant Expansion Tank And Windshield Washer Fluid Reservoir Filler Tube

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the clip -3- and remove the connector -5- from the coolant expansion tank -1-.

-- Remove the bolts -arrows- and place the coolant expansion tank -1- on top of the engine with the coolant lines connected.

-- If equipped, remove the battery jump start terminal -3- on the front engine mount bolt -2- using the Union Nut Socket T40055.

Fig 2: Identifying Union Nut Socket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -5- and the bracket -4-.

Fig 3: Identifying Engine Mount Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the engine mount bolts -1- ; -3- ; and -5- and then remove the engine mount upward.