Transmission Output Speed Sensor -G195-: Procedure

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the ATF. Refer to ATF, DRAINING AND FILLING .

-- Remove the ATF pan. Refer to Removing .

-- Remove the ATF strainer. Refer to Removing .

-- Remove the valve body. Refer to Removing .

-- Remove the bolt -2- from the Transmission Output Speed Sensor -G195-.

Fig 1: Identifying Transmission Input G182 & Output G195 Speed (RPM) Sensors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Transmission Output Speed Sensor from the transmission housing.

Install in reverse order of removal. Note the following:

-- Push the Transmission Output Speed Sensor all the way into the transmission housing.

-- Tighten the bolt -2- from the Transmission Output Speed Sensor -G195-.

-- Install the valve body. Refer to Installing .

-- Install the ATF strainer. Refer to Installing .

-- Install the ATF pan. Refer to Installing .

-- Fill the ATF and check the level. Refer to ATF LEVEL, CHECKING .