LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Automatic Transmission 09G - Gears & Hydraulic Controls (Hatchback)) >> 38 Gears, Hydraulic Controls >> Description And Operation >> Valve Body Wire Routing, Connectors And Bracket

Valve Body Wire Routing, Connectors And Bracket

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Wiring routing and connectors installed location.

NOTE:

In this chapter the information regarding working on the solenoid valves is shown in illustrations.

Mark the solenoid valve and/or sensor and its connector before disconnecting them.

Fig 1: Identifying Wire Routing, Connectors And Bracket On Valve Body
GWWN38-10060Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. 1 -

    Solenoid Valve 4 -N91-

  2. 2 -

    Solenoid Valve 6 -N93-

  3. 3 -

    Solenoid Valve 5 -N92-

  4. 4 -

    Solenoid Valve 9 -N282-

  5. 5 -

    Solenoid Valve 10 -N283-

  6. 6 -

    Solenoid Valve 3 -N90-

  7. 7 -

    Solenoid Valve 1 -N88-

  8. 8 -

    Solenoid Valve 2 -N89-

  9. A -

    Transmission Output Speed Sensor -G195- connector

  10. B -

    Transmission Input Speed Sensor -G182- connector

Bracket for connectors, securing the wires

NOTE: The -arrows- point to the fastening points for the lines on the valve body.
Fig 2: Identifying Bracket For Connectors, Securing Wires
GWWN38-10061Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. 1 -

    Bracket for the Transmission Output Speed Sensor -G195- connector

  2. 2 -

    Bracket for the Transmission Input Speed Sensor -G182- connector

  3. 3 -

    Transmission Fluid Temperature Sensor -G93-

  4. 4 -

    Lever

scientia non olet · About LEMON Manuals