Data Bus On Board Diagnostic Interface -J533-: Removal

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the steering column lower trim, refer to Removal and Installation .

-- Release and disconnect the connector -2- on the Data Bus On Board Diagnostic Interface -J533- -1-.

Fig 1: Identifying Data Bus On Board Diagnostic Interface And Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the pins -arrows- together and remove them from the openings.

-- Remove the Data Bus On Board Diagnostic Interface -J533- -1-.