Clutch Position Sensor -G476-: Installing

WARNING: This page is about a different car, the 2013 Volkswagen Beetle and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE: Allocate all components.

If the hose/line assembly or pipe line was removed:

Fig 1: Identifying Hose/Line Assembly, O-Ring, Master Cylinder Connection & Securing Clip

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the hose/line assembly or pipe -1- with a new seal or O-ring -2- into the clutch master cylinder connection -4- until the clip -3- engages.

-- Pull on the hose/line assembly or pipe to make sure it is secure.

-- After removing the Hose Clamps up to 25 mm Diameter 3094 bring the return hose back to its original shape.

-- Bleed the clutch system, refer to CLUTCH SYSTEM, BLEEDING .

-- Install the battery tray and the battery, refer to [For engine(s) CVCA, CPRA, CBTA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .

-- Install the air filter housing, refer to REMOVAL AND INSTALLATION

-- Connect the battery and follow the procedure regarding what to do after connecting the battery, refer to [For engine(s) CVCA, CPRA, CBTA, CPKA, CPLA, CJAA, CBUA, CPPA, CCTA, CBFA] Removal and Installation .