Drive Axle, Triple Roller Joint AAR2600I: Disassembling

WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, 2013 Volkswagen Beetle, and 2012 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.

-- Open both clamps at inner joint and slide back CV boot.

-- Remove joint from drive axle.

-- Remove securing ring.

Fig 1: Identifying Removal Of Circlip Using Pliers

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 - Pliers (commercially available)

or Circlip Pliers VW161A

-- Insert drive axle in vise.

-- Press the triple roller star off the drive shaft.

Fig 2: Identifying Triple Roller Star Pressed Off From Driveshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull off CV boot from shaft.

-- Clean shaft, joint and groove for oil seal.